Parkside PHD 100 D2 Manuel d'utilisateur télécharger pdf (Page 35)

35

GB

• Release the lever of the gun (

A

10).

• Turn off the pressure by its ON / OFF

switch (

A

5).

• Turn off the water tap.

• Pull the lever of the gun (

A

10) to vent

the pressure existing within the system.

• Disconnect the mains plug.

• Disconnect the pressure washer from

the water mains.

Using detergents

The washer was designed for operation

with a neutral detergent based on a bio-

logically decomposable anionic tenside.

Other detergents or chemical substances

could impair the safety of the washer and

damage it.

E

Fixing the Wheels

The back wheels on the chassis (9) can be

xed in order to secure the pressure wash-

er against undesired rolling away.

• To do this push the two bolts (16) out-

wards and downwards.

The wheels are now no longer able to

turn.

• To cancel the wheel xing, push the

two bolts (16) upwards.

F

Removing the Chassis

The pressure washer can also be used

without the chassis (9).

• Press the release button (18) on the

front locking point. Hold the chassis (9)

securely in the front area and pull the

pressure washer upwards.

At the same time, tilt the pressure

washer slightly to the rear.

• To reinstate, insert the device into the

rear area of the chassis (9). Push down

on the device down and press the re-

lease button (18) at the same time. The

device clicks into the chassis.

Cleaning and Mainte-

nance

Pull out the power plug before

every maintenance operation. There

is a risk of electrocution or of injury

from moving parts.

Cleaning

Never direct the water jet

against the washer, nor clean

the washer under owing

water. This could give rise to

the danger of electric shock

and damage the washer! .

Always keep the washer clean. Do

not use any detergents or solvents.

• Always keep the ventilation slots clean

and free.

• Only clean the pressure washer with a

soft brush or a slightly moist cloth.

• In case a nozzle of the jet tube

(12/13) is clogged up, use the nozzle

cleaning pin (15) to remove the object

from the nozzle.

G

If necessary, take off the water con-

nection with the lter insert (8) and

clean the lter insert.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Commentaires sur ces manuels

Pas de commentaire