Parkside PDKS 120 B3 Manuel d'utilisateur télécharger pdf (Page 37)

37 GB

General safety advice General safety advice / Assembly

device. Pull the plug out of the mains socket im-

mediately and have the device repaired by a

suitably qualiﬁed person or at the Customer

Service Centre.

Always work with the mains lead leading

away from the rear of the device.

If a dangerous situation arises, pull the mains

plug immediately out of the mains socket.

Always switch on the electrical power tool before

moving the workpiece against it. Otherwise

there is the risk of kickback.

Do not cut moist materials or damp surfaces,

Use only undamaged, defect-free saw blades

7

.

Distorted or blunt saw blades

7

can break or

cause a kickback.

Ensure that the teeth on the saw blade

7

point

downwards before you mount it in the device.

DANGER OF INJURY! Keep your hands

away from the area of the saw blade.

Before sawing, check the workpiece for foreign

bodies such as nails etc. and remove them. In-

jury and / or damage to property may result from

the saw blade striking nails etc. embedded in

the workpiece.

Always keep the device clean, dry and free

from oil or grease.

Switch oﬀ the device before you remove any

wood residue from around the saw blade.

Otherwise you could become injured.

HAZARDOUS DUSTS /

VAPOURS! Any noxious dusts or vapours

generated from sawing represent a risk to the

health of the person operating the device and

to anyone near the work area.

Do not saw materials containing substances

harmful to health.

Do not use the tool on materials containing

asbestos. Asbestos is a known carcinogen.

Make sure you have adequate ventilation.

Wear protective glasses, hearing

protection, dust protection masks

and protective gloves.

Q

Advice on use

Push the workpiece slowly and with minimum

pressure on to the saw blade.

Reduce the rate of advance when you are

cutting thicker material.

Hold the workpiece ﬁrmly on the table with

both hands and push it slowly towards the saw

blade. Otherwise the saw blade may twist or

break.

Avoid making any sharp changes in direction

during sawing to prevent the saw blade from

twisting or tearing.

Before starting the saw cut, drill a hole at a

corner or internal cut-out in the workpiece and

start sawing from the hole.

Use the correct saw blade. The choice of saw

blade depends on the thickness and type of

material and the intended cut.

Select a saw blade with ﬁne teeth to saw thin,

hard materials.

Use a narrow saw blade to saw small radius c

uts.

Q

Assembly

DANGER OF INJURY!

Pull the mains plug out of the socket before you

carry out any task on the device,

Q

Attaching the blade guard

9

(see Fig. A)

Push the screw

10 c

from the inside through the

slot in the blade guard

9

.

From the outside of the blade guard

9

, place

the guide plate

10 b

on to the screw

10 c

.

The longer of the angled sides of the guide

plate

10 b

reaches around the cover

9

.

Attach the blade guard

9

between the two at-

tachment arms

11

and insert the two screws

10 c

through the openings provided for them in the

attachment arms

11

.

Ensure that the upwardly curved end of the

blade guard

9

is at the top.

Put the plain washers

10 a

on from the outside

of the attachment arms

11

.

Screw the knurled nuts

10

on to the two screw

ends

10 c

.

1 2 ... 32 33 34 35 36 37 38 39 40 41

Commentaires sur ces manuels

Pas de commentaire