Parkside PMGS 12 B2 Manuel d'utilisateur télécharger pdf (Page 12)

12 GB/IE/CY

OperationGeneral safety advice for electrical power tools / Operation

Q

Special safety

advice for polishing

Do not use the polishing bonnet if it

has any loose parts, in particular the

fastening cords. Tuck the fastening cords

away or trim them. Loose fastening cords rotat-

ing with the attachment could catch your ﬁngers

or become trapped in the workpiece.

Q

Special safety advice for

working with wire brushes

a) Bear in mind that wire brushes lose

pieces of wire during normal use. Do

not overload the wires by applying too

much pressure. Flying pieces of wire can very

easily penetrate thin clothing and / or skin.

b) U

se a guard, if recommended, but m

ake

sure that the wire brush does not come

into contact with the guard. The diameters

of disc brushes and cup brushes can increase

due to contact pressure and centripetal forces.

Q

D

evice-speciﬁc safety instructi

ons

for small drill PMGS 12 B2 and

mains adapter-PMGS 12 B2-1

When you use the drill / grinder wear

the following protective equipment:

safety glasses and protective gloves.

For indoor use only!

CAUTION! The tool continues to rotate

after it has been switched off! Avoid

contact with rapidly rotating drill / grinder com-

ponents.

Securely support the

workpiece. Use clamps or a vice to grip the

workpiece ﬁrmly. This is much safer than holding

it in your hand.

Never support your-

self by placing your hands near or in

front of the device or the workpiece

surface. A slip can result in injury.

Avoid contact with moving sanding or

grinding tools.

DANGER OF FIRE FROM FLYING

SPARKS!

Abrading metal creates ﬂying sparks. For this

reason, always make sure that nobody is placed

in any danger and that there are no inﬂamma

ble

materials near the working area.

DUST HAZARD! Any

harmful / noxious dusts generated from machin-

ing represent a risk to the health of the person

operating the device and to anyone near the

work area.

Wear a dust mask!

NOXIOUS FUMES!

Ensure that there is adequate ventilation when

machining surfaces containing plastic or cov-

ered with paint, varnish etc.

Do not soak the materials or the sur-

face you are about to work on with

liquids containing solvents.

Avoid abrading paints containing lead

or other substances hazardous to

health.

Do not machine materials containing

asbestos. Asbestos is a known carcinogen.

Do not machine moist materials or

damp surfaces.

NOTE! Do not allow the tool to come to a

standstill by overloading it!

Switch the device off

and allow it to come to a standstill be-

fore you put it down.

Always keep the de

vice

clean, dry and free of oil or grease.

Children or persons who lack the knowledge or

experience to use the device or whose physical,

sensory or intellectual capacities are limited

must never be allowed to use the device without

supervision or instruction by a person responsible

for their safety. Children must never be allowed

to play with the device.

Q

Operation

Never use the device for a purpose

for which it was not intended or with

non-original parts / accessories. The use

of tools or accessories other than those recom-

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 42 43

Commentaires sur ces manuels

Pas de commentaire