Parkside PSTD 800 A1 Manuel d'utilisateur télécharger pdf (Page 10)

6

PSTD 800 A1

GB

IE

CY

Saw blade type

suitable unsuitable

Initial operation

Fitting/changing the saw blade

Always remove the plug from the power socket

before working on the appliance.

♦ Flip up the pivoting guard

.

♦ Turn the quick-release chuck

and hold it in

this position.

♦ Press the required saw blade into the quick-

r

elease chuck as far as the limit stop.

♦ Release the quick-release chuck

– it must

return to its initial position. The saw blade is

now locked.

Fitting the guide fence

The guide fence can be ﬁ xed on the left or right

of the appliance.

♦ Undo both the clamping screws on the insertion

openings

.

♦ Push the guide fence

into the insertion open-

ings .

♦ Retighten the two clamping screws.

Connecting the sawdust extraction

appliance

♦ Push the extraction connector into the vacuum

extraction duct until it is secured.

♦ Attach an approved dust and sawdust extractor

to the e

xtraction connector .

Fitting the sliding shoe

When working on sensitive surfaces, you can ﬁ t

the sliding shoe on the baseplate to avoid

scratching the surface.

♦ Mount the sliding shoe

onto the baseplate

and press it up at the back until it clicks into

place on the baseplate .

♦ To remove the sliding shoe

, unfasten it at

the rear of the baseplate and slide it oﬀ

forwards.

Operation

Setting the cutting angle

♦ Undo the clamping screws with the Allen

key

and pull the baseplate to the rear.

♦ Adjust the cutting angle to 0°/15°/30°/45°

with the aid of the markings on the baseplate

.

Push the baseplate to the front so that the

locking pin engages in the toothing .

♦ Retighten the clamping screws

with the Allen

key .

Setting the stroke rate

♦ Use the stroke rate preselection adjusting

wheel to set the required stroke rate.

Setting the pendulum stroke

♦ You can use the pendulum stroke switch to set

the pendulum movement of the saw blade

.

You can achieve ﬁ ne, clean cut edges without

pendulum movement (setting “0”). Switch the

pendulum movement oﬀ when working on thin

workpieces. You can achieve an increasingly

fast workrate with activated pendulum stroke

(settings 1–3).

Switching on/oﬀ

Switching the appliance on:

Press the ON/OFF switch

.

Switching the appliance oﬀ :

Release the ON/OFF switch

.

Switching to continuous operation:

Press the ON/OFF switch

and lock it in this

position with the ON/OFF switch lock button .

IB_90967_PSTD800A1_GB_IE_CY.indb 6IB_90967_PSTD800A1_GB_IE_CY.indb 6 02.08.13 10:1302.08.13 10:13

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Commentaires sur ces manuels

Pas de commentaire