Parkside PHKSA 18-Li A1 Manuel d'utilisateur télécharger pdf (Page 11)

PHKSA 18-Li A1

Removing the battery pack:

♦ Press the release button and remove the

battery pack

Checking the battery charge level

♦ Press the battery charge level button to

check the status of the battery (see also main

diagram). The status/remaining charge will be

shown on the battery display LED as follows:

♦ RED/ORANGE/GREEN = maximum charge/

power

RED/ORANGE = medium charge/power

RED = low charge – charge the battery

Checking the blade guard

♦ Pull back on the release lever for the blade

guard as far as the stop.

The blade guard

must move freely without jam-

ming and must spring back into its starting position

automatically when you let go of the release lever

for the blade guard .

Initial use

Fitting/changing the saw blade

Always remove the battery pack before changing

the saw blade !

1. Set the cutting depth (using the locking screw

)

to the minimum position, 0 mm.

2. Swing the blade guard

back using the

release lever and put the appliance down.

3. Press the spindle lock button (until it engages)

and use the Allen key to release the clamping

screw . Now remove the clamping screw

and the clamping ﬂ ange (see also Fig. A).

Fig. A Changing the saw blade

4. Remove

saw blade.

5. Fitting a saw blade

is carried out in the reverse

order.

6. Press the spindle lock button

(until it engages)

and use the Allen key

to tighten the clamping

screw

WARNING!

► The arrow on the saw blade must corre-

spond to the arrow showing the direction

of rotation (running direction shown on the

appliance).

■ Ensure that the saw blade is suitable for the

rotational speed of the tool.

Rip fence

♦ Loose the wing screw and insert the rip

fence into the rip fence slot .

♦ Set the desired cut width with the help of the

scale on the rip fence and the cut out in the

base plate (see also Fig. B).

The right-hand recess in the base plate is for a

cutting angle of 0°. The left-hand recess in the

base plate is for a cutting angle of 45°.

Fig. B: Cutting width 3 cm

♦ Retighten the wing screw .

Connecting the sawdust extraction

device

♦ Attach the dust extraction adapter to the chip

ejector .

Optional depending on the diameter of the dust

and sawdust extractor.

♦ Connect an approved dust and chip extraction

device.

IB_102867_PHKSA18-LiA1_LB6.indb 8 13.10.14 14:14

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Parkside PHKSA 18-Li A1 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Parkside PHKSA 18-Li A1