Parkside PSTDA 18-Li A1 Manuel d'utilisateur télécharger pdf (Page 10)

6

PSTDA 18-Li A1

GB

■ Secure the workpiece. Use clamps/a vice to

hold the workpiece ﬁ rmly. This is safer than

simply holding it in your hand.

■ Never work on moistened materials or damp

surfaces.

■ Dust may be hazardous! When working for

extended periods on wood and, in particular,

materials that produce dusts that are hazardous

to health, connect the appliance to an appropri-

ate dust extraction device.

■ Wear a dust mask.

■ Ensure there is suﬃ cient ventilation.

Genuine accessories/auxiliary equip-

ment

■ Only use the accessories and auxiliary

equipment that are speciﬁ ed in the operat-

ing instructions or that are compatible with

the appliance.

Information on saw blades

Parkside basic equipment includes saw blades

principally for use with wood and metal.

▯ 2 saw blades for general wood cutting

▯ 1 saw blade for light metals up to 3 mm

NOTE

►

You can use any saw blade provided it is

ﬁ tted with a suitable mounting (single-lug

shank).

Saw blade type

suitable unsuitable

Before initial use

Charging the battery (see Fig. A)

CAUTION!

► Always unplug the appliance before you

remove the battery pack from or connect the

battery pack to the charger.

HINWEIS

►

Three appliances - three compatible batteries.

Interchangeable!

(see chapter ordering a replacement battery)

■ Never charge the battery pack when the ambi-

ent temperature is below 10°C or above 40°C.

♦ Connect the battery pack to the rapid bat-

tery charger (see Fig. A).

♦ Push the mains plug into the mains power

socket. The control LED will light up red.

♦ The green control LED indicates that the

charging process is complete and the battery

pack is ready.

♦ Push the battery pack back into the appliance.

■ Never recharge a battery pack again im-

mediately after rapid charging. This could

overcharge the battery pack, thus reducing the

lifespan of the battery and charger.

■ Switch oﬀ the charger for at least 15 minutes

between successive charging sessions.

Also disconnect the power plug from the mains

power socket.

Attaching/disconnecting the

battery pack to/from the appliance

Inserting the battery pack:

♦ Allow the battery pack to click into place in

the appliance.

Removing the battery pack:

♦ Press the release button and remove the

battery pack.

Checking the battery charge level

♦ Press the battery charge level button to

check the status of the battery (see also main

diagram).

The status/remaining charge will be shown on

the battery display LED as follows:

♦ RED/ORANGE/GREEN = maximum charge/

power

RED/ORANGE = medium charge/power

RED = low charge – charge the battery

IB_102866_PSTDA18-LiA1_LB4.indb 6 22.10.14 13:58

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 88 89

Commentaires sur ces manuels

Pas de commentaire